Manualshelf

User Manual

ManualsBrandsBarco ManualsComputers & AccessoriesMAIN-61771 | Small Medium Size Meeting Room Wireless Presentation System
71727374757677787980
6. CSE-200 Configurator
Image 6-42
Time server setup
The current time is indicated next to Current time.
3. Check the radio button next Use NTP.
4. Enter a NTP se rver address next to NTP servers. E nter the IP addre ss or server name.
Note: Multiple servers (maximum 5) can be added, s eparated by a com ma.
5. Click Save changes to apply.
A synchronization with the NT P server takes place. The status field indicates the progress.
6.26 Energy savers
About standby
Standby after (minute s): If there is no client connection dete cted during the standby timeout period, the Bas e Unit will enter the
selected s tandby m ode.
Default setting: Time to standby: 10 min, the Base U nit will enter the Eco standby m ode.
Eco standby
When the Base Unit enters ECO s tandby mode, it will disable the HDMI output signal and go in low power mode. The Base Unit’s
LEDs will be breathing white to indicate the ECO standby mode.
Power c onsum ption in E co standby: 2.6W
The Base Unit w ill w ake up with one of the following actions:
• Button or app connecting with the Base Unit
• Press the standby button on the Base Unit
• "Wake up" signal over the network
• Pairing a Button on the Base Unit’s USB port
• Detection of display hot plug
Deep standby
When the Base U nit goes in D eep standby mode, it will s hut do wn all processes, including the W i-Fi access point and the (secondary)
LAN connection.
For devices with two LAN interfaces (e.g. CSE-800), when there is an active network connected to the primary LAN connection
and Corporate network is enabled, the pr imary LAN interface will rem ain active and t he B ase Unit’s LEDs will be breathing white to
indicate this standby mode. Otherwise, The Base Unit’s LEDs will be dark.
Power c onsum ption in Deep standby: 0.4W
The Base Unit w ill wake up when the stand by button on the Base Unit is pressed, or
when the primary LAN interface remains active, a detection of HDM I input hot plug or button or app con necting with the Base Unit’s
primary LAN interface.
R5900023 CLICKSHARE CSE-200 24/05/2017
59