User manual

6. Configuration schemes
The D320L Digitizer can be chained in order to generate more windows on the output display (four win-
dows per D320L Digitizer).
How to set up a D320L chaining configuration
1. Connect the RS232 communication port of the local control PC with the COM1 RS232 input port of the
first D320L Digitizer. This Digitizer will act as the master, all following Digitizers are slaves.
2. Connect the LOOP OUT with the LOOP IN of the next D320L Digitizer in the chain.
3. Connect the COM2 RS232 output port with the COM1 RS232 input port of the next D320L Digitizer in
the chain.
4. Repeat step 2 and 3 until all D320L Digitizers in the chain are connected.
5. Connect the LED-WALL OUTPUT from the last D320L Digitizer in the chain with the display.
6. Provide the available video sources to the input modules of the D320L Digitizers.
7. Configure the D320L Digitizers and the Display with the control software installed on the local control
PC.
6.3 Stacking config uration
Scheme
Image 6-3
For some large installations is it necessary to divided a complete large display into two ore more screens
depending on the used frame rate and the amount of pixels per line and the total lines of the complete
display. For each screen a D320L Digitizer is used in stacking configuration. Consult Barco n.v. for advise
about the number of D320L Digitizers to be stacked.
22
R5976542 D320L DIGITIZER 15042003