Instruction manual

4. Setup
Image 4-2
1 Function keys
user programmable keys with functions f
or direct access.
2 MENU Menu key, to enter or exit the Toolbar menu
.
3 Address key
(recessed key), to enter the address of the projector (between 0 and 9). Press the recessed
address key with a pencil, followed by pressing one digit button between 0 and 9.
4
LOGO key allows to recall the stored Logo (not in
PiP mode)
5
PAUSE to stop projection for a short time, press ’PAUSE’. The image disappears but full power is
retained for immediate restarting.
6
STBY standby button, to start projector whe
n the power switch is switched on and to switch off the
projector without switching off the power switch.
Attention : Switching to Standby. When the projector is running and you want to
go to standby, press the standby key for 2 seconds.
7
MUTE
to interrupt the sound reproduction (audio = optional.
8
AUTOIMAGE Auto image, to center the image on th
eactiveLCDsurface.
9 Digit buttons direct input selection.
9b
SOURCE button this button allows to switch through the active (scanned) inputs
10 Lens control
use these buttons to obtain the desired ZOOM, SHIFT, FOCUS.
11
VOL use this button to obtain the desire
d sound level (audio = optional)
12 Picture controls use these buttons to obtain the desir
ed picture analog level.
R5976837 BARCO ID R600/R600+ 21/09/2006 23