Instruction manual

6. Advanced

Image 6-4

The Barco logo on the menu indicates the presence of a signal, the digit indicates the shortcut key on the

RCU.

The 3 first sources (Data on BNC’s, Component Video & RG(s)B) refer to the 5-cable input, the position of the

indication “1” will always show which BNC configuration is selected.

When to select “Data on BNC’s”

Select Data on BNC’s when a data signal is connected to the BNC’s

When to select “Component video” ?

Select Component video when a video signal of the type (R-Y/Y/B-Y) is connected on the BNC’s.

When to select RG

BVideo?

Select RG

B Video when an RGB video signal (15 KhZ) with Sync on green or sync on H is presented on the BNC’s.

This signal is routed to the video circuit and is projected in a Video Window.

6.2.2 Composit

eVideo

How to sel

ect one of the 7 composite video inputs ?

1. Press MENU to activate the Tool bar

2. Press ↓ to Pull down the Source Selection menu

3. Use ↑ or ↓ to select Composite video

4. Press → to Pull down the submenu

5. Use ↑ or ↓ to select one of the different video inputs (image 6-5)

Note: Video2 is an optional Video input and is only displayed in case the optional Video/Audio layer is installed.

If the extended mode is disabled, the submenu contains only 1 selection (2 selections if the Audio & Video op tion is

installed).

6. Press ENTER to confirm your choice

A white bull

et indicates the selected composite video source which now appears on the screen.

R5976837 BARCO ID R600/R600+ 21/09/2006