Instruction manual

6. Advanced
Note that native resolution refers here to the source and does thus only have sense when handling data sources (greyed out for
video sources).
Depending on the type of projector the “show native resolution” function will handle the sources as follows:
Source
Projected image
Name Ratio Resolution Ratio Resolution Display
xga
4:3 1024x768 4:3 1024x768 image centered +side blanked
sxga
5:4 1280x1024 5:4 1280x1024 image centered +side blanked
sxga+
4:3 1400x1050 4:3 1400x1050 image centered
uxga
4:3 1600x1200 4:3 1600x1200 scroll image
Table 6-1
Show native resolution = ON
The Full screen representation function on the other hand forces to use the complete native resolution of the
LCD panels.
How to enable the “Show native resolution” function?
1. Press MENU to activate the Tool bar
2. Press → to select the Image item
3. Press ↓ to Pull down the Im age menu
4. Use ↑ or ↓ to select Show native resolution (
image 6-28)
5. Press → to pull down the menu
6. Use ↓ or ↑ to select On
7. Press ENTER
A white bullet shows the selection
Image 6-28
The default mode is used if the Sh ow native resolution and the Fu ll screen representation are off.
The default mode s
hows always the native ratio and forces the native resolution of the panels (part of the
image blanked where needed)
When show native resolution is ON and the resolution of the source is higher than the panel resolution , use
the arrow keys to scroll through the image (pan).
R5976837 BARCO ID R600/R600+ 21/09/2006 53