User guide

16 Nio

Connecting the signal cables

TO CONNECT THE SIGNAL CABLES TO THE DISPLAY:

To get access to the connectors, remove the connector compartment

cover by pulling down the 2 clips at the top of the cover.

The location of the connectors depends on the display type:

Figure 10: Inputs E-3620, MDNG-5121

Figure 11: Inputs MDNC-3121, MDNG-2121 and MDNG-6121

Figure 12: Inputs MDNC-2121

• Connect one end of the DVI/DisplayPort cable to the DVI/

DisplayPort input of the display (1). Connect the other end of the

DVI/DisplayPort cable to the DVI/DisplayPort connector of the

display controller board.

• Connect a PC USB downstream connector to the display’s USB

upstream connector by means of a USB cable (2).

• Connect any USB device to one of the display’s USB downstream

connectors (3)

• Connect the DC power input (4) of the display to the external DC

power supply. Connect the other end of the external DC power

supply to a grounded power outlet by means of the proper power

cord delivered in the packaging.

3 4