User guide

Nio 17
Routing the cables
• Bind the cables in the connector compartment together with the
cable tie inside the connector compartment.
• Put the connector compartment cover back on the display. Pay
attention that the signal cables are positioned under the bulge in
the cover.
• Push the cables into the clips on the rear of the tilt & swivel foot.
• Bind the cables together above and under the foot, by means of
the 2 velcro strips attached to the inside of the foot cover (packed
inside the accessory box).
• At last, put the foot cover back in place.
Re-attaching the covers
Figure 13: Installing the cover
1 The foot cover is packaged separately in the accessory box. Unpack
the foot cover.
2 Push the upper side of the cover onto the foot, so that the hooks
inside the cover are positioned right under the bulges at the rear of
the foot.
(2)