Installation manual

4. Installation Setup
J15 1 Red Horizontal Scan connector
J25 1 Green Horizontal Scan connector
J35 1 Blue Horizontal Scan connector
J15 2 Red Vertical Scan connector
J25 2 Green Vertical Scan connector
J35 2 Blue Vertical Scan connector
Putting back the protection plate
1. After setting the scan connectors, put the cover back in place and secure it with the bolts.
2. Reinstall the top cover.
The following procedure can only be done after power (mains) connection. So, first continue with the projector
setup and the connections and then return to this procedure.
Scan position check
To check the scan position i.e. the orientation of the scan connectors proceed as follows:
1. Switch on the projector.
The projector starts up on the last selected source.
2. Press the ADJUST key on the RCU.
The Adjustment Mode menu will be displayed.
3. Push the ↑ or ↓ keys to highlight Service.
ADJUSTMENT MODE
Select a path from below :
RANDOM ACCESS
INSTALLATION
SERVICE
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 4-1
4. Press ENTER to select.
The Service Mode menu will be displayed.
5. Push the ↑ or ↓ keys to highlight Projector Set-Up and press ENTER.
SERVICE MODE
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
VOLTAGE DIAGNOSTICS
PROJECTOR DIAGNOSTICS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 4-2
The Projector Set-Up menu will be displayed.
6. Push the ↑ or ↓ keys to highlight Identification.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0
ABL CONTROLLER
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 4-3
20 R5976257 BARCO REALITY 909 15/03/2003