Installation manual

6. Source Connections
coming from the computer is limited to 60 cm due to interferences. The RGB analog input accepts only sources with a horizontal
frequency of 32 kHz and higher.
To connect a source lower than 32 kHz, an Optional Decoder + Limo Pro (R9828631) has to be installed.
Computer
Port on projector
(R9828120)
Magik Interface
to computer
to monitor
PORT 3
Image 6-2
Port 3
Pin configuration D9 connector of Port 3
Pin # Signal
1
Not Connected
2
Ground RGBS
3 Red
4
Green
5
Blue
6
Ground RGBS
7
Ground RGBS
8
Hor. / Comp. Sync.
9
Vert. Sync.
Table 6-2
Pin configuration D9 connector of Port 3
Port 3 Input Selection
1. Press digit button 3 on the RCU.
Settings on module level
In the case of this second R
GB input there are three different settings:
•75Ω Termination Resistor.
• BlueinGreenSwitch.
• Force Negative Sync Switch.
28
R5976257 BARCO REALITY 909 15/03/2003