Installation manual

7. Installation Adjustment Mode
Following screen will be displayed:
CRT PROJECTION ANGLE
ADJUSTMENT
DURING THIS PROCEDURE? RED
ON GREEN AND THEN BLUE ON
GREEN CROSSHAIRS WILL BE
ALIGNED WITH THE GREEN CRT
LOOSEN BOLTS A, B, C AND D TO
PIVOT THE RED CRT AND BOLTS
E, F, G AND H TO PIVOT THE
BLUE CRT
<ENTER> to continue
<EXIT> to return
Menu 7-7
2. Press ENTER to begin with the angle adjustment of the Red CRT.
3. Loosen bolts A, B, C and D on the front of the projector to pivot the Red CRT until the center of the red image and the center of
the green image coincide.
Image 7-12
Loosen bolts A, B, C and D
Action on CRT: Move the Red CRT
towards the Green CRT
Case 1: Red crosshair on the
Left of the Green crosshair
Action on CRT: Move the Red CRT away
(to the outside) from the Green CRT
Case 1: Red crosshair on the
Right of the Green crosshair
Red
crosshair
Green
crosshair
Red
crosshair
Green
crosshair
Image 7-13
Red CRT Projection Angle Adjustment
4. When the angle of the Red CRT is corrected, tighten the four bolts.
5. Press ENTER to continue with the angle adjustment of the Blue CRT.
6. Loosen bolts E, F, G and H on the front of the projector to pivot the blue CRT until the center of the blue image and the center of
the green image coincide.
R5976257 BARCO REALITY 909 15/03/2003
43