User's Manual

1. This Transmitter must not be co-located o r operating in conjunction with any other antenna or transmitter.
2. This equipment com plies with RF radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and ope rated with a minimum distance of 20 cm betw een the radiator and your body.
Base Unit F CC ID: 2AAED-R9861580
Button F CC ID (model R9861006D01): X F6 -RS9110N1103
Button FC C ID (model R9861500D01): 2AAED-R9861500D01
ClickShare Button R9861500D01 has been tested and mee ts the FCC RF ex posure guidelines.The max imum SA R v alue reported is
0.915W/kg.
Canada, Industry Canada (IC) Notices
This device c omplies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including inter ference that may cause undesired
operation of t he device.
Radio Frequency (RF) Exposure Information
The radiated output power of the Barco Wireless Device is below the I ndustry Canada (IC) radio frequency exposure limits. Th e Barco
Wireless Dev ice should be used in such a m anner such that the potential for human contact d uring normal opera
tion is minimized .
Caution: Exposure to Radio Frequency Radiation.
1. To comply with the Canadian RF exposure comp liance requirements, this de vice and its antenna must not be co-located or operating
in c onjunction with any other antenna or transmitter.
2. To comply with RS S 102 RF exposure compliance requirements, a separa tion distance of at least 20 cm mus t be maintained between
the antenna of this device and all persons.
Base Unit IC ID: IC: 21559-R9861580
Button IC ID (model R9861006D01): 8407A-RS9 110N1103
Button IC ID ( model R9861500D01): 9393B -R9861500D 01
IC Antenna statement
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
This radio transm itter 21559-R9861580 has been approved by Industry Canada to o
perate with the antenna types listed below with the
maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having
a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this dev ice.
Typ e: Dipole
Maximum P eak Gain: 2 dBi
Impedance: 50 Ohm
Indoor use only warning
Operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harm ful interference to c o-channel mobile satellite
system s.
Canada, avis d’lndustry Canada (IC)
Le présent appa reil est conforme aux CNR d’Industrie Canada applicables aux a ppareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique s ubi, mêm e si le brouillage est susceptible d’en compromettre le fonctionnement.
Informations concernant l’exposition aux fréquences radio (RF)
La puissance de sortie ém ise par l’appareil de sans fil Barco es t inférieure à la limite d’exposition au x fréquences radio d’Industry Canada
(IC). Utilisez l’appareil de sans fil Barco de façon à minimiser les contacts humains lors du fonctionnement normal.
Avertissement: L’exp osition au x rayonnements fréquences radio