user manual

136 DX-700 • User’s Guide • Rev 02
4. Operation
DX-700 Management Menu Operations
auJTMM=j~å~ÖÉãÉåí=jÉåì=léÉê~íáçåë
The DX-700 Management Menu provides access to management functions such as
viewing the status of banks, outputs and tiles, running diagnostic checks, performing
genlock functions, resetting the system and various “expert” modes.
 Use the following steps to use the DX-700 Management Menu:
1. From the Home Menu, press {DX-700 Management}.
Figure 4-72. DX-700 Management Menu
2. Select the desired function:
~ Press {Status} to display the DX-700 Status Menu, which is used to
view the status of bank outputs, the power status of the tiles, and the test
pattern status for each bank, output and tile. You can also use this
function to name your DX-700 unit. Refer to the “
Using the DX-700
Status Menu” section on page 138 for instructions.
~ Press {Ethernet} to display the Ethernet Menu, which is used to change
Ethernet modes, the IP address and the Subnet Mask. Refer to the
“
Using the Ethernet Menu” section on page 142 for instructions.
~ Press {Diagnostic} to display the DX-700 Diagnostics Menu, which is
used to test keys, communications and system functions. Refer to the
“
Using the Diagnostics Menu” section on page 143 for instructions.
~ Press {Front Panel} to display the Front Panel Display Adjustments
Menu, which is used to calibrate and adjust touch screen brightness.
Refer to the “
Using the Front Panel Display Adjustments Menu”
section on page 145.
~ Press {System Reset} to display the System Reset Menu, which
enables you to reboot the system or restore it to factory defaults. Refer
to the “
Resetting the System” section on page 145 for instructions.