user manual

DX-700 • User’s Guide • Rev 02 151
4. Operation
DX-700 Management Menu Operations
5. To change the video that is shown on the monitor, press {Output} to display the
Output Selection Menu:
Figure 4-89. Output Selection Menu
~ To display the entire bank on the monitor (essentially, the canvas), press
the
Bank button (above the chassis graphic).
~ To display a single output, scaled to fit the monitor, press the output
connector.
6. Press {Previous} to return to the Monitor Output Menu.
7. Press {Previous} again to return to the DX-700 Management Menu.
This completes the
Monitor Setup procedure.
rëáåÖ=íÜÉ=bafa=jÉåì
Extended Display Identification Data (EDID) is a VESA standard data format that contains
information about a display device and its resolution, both preferred and allowed. Each
input module contains two EDID files (one for digital, one for analog), which are both stored
in non-volatile memory. These EDID files may be read by an external computer’s graphics
card when the computer’s output is connected to DX-700 via the DVI-I or HD-15 connector
during boot-up.
This procedure enables you to set EDID for any DVI-I or HD-15 input connector (even ones
that have not been set up).
 Use the following steps to set EDID:
1. From the Home Menu, press {DX-700 Management}.
2. Press {EDID} to display the Input Selection Menu. On the menu, all input
modules are active buttons, regardless of banks.