user manual

154 DX-700 • User’s Guide • Rev 02

4. Operation

DX-700 Management Menu Operations

 Use the following steps to set the genlock source for the outputs in a bank:

1. From the Home Menu, press {DX-700 Management}.

2. Press {Genlock} to display the Bank Sync Menu.

Figure 4-92. Bank Sync Menu (sample)

Below the menu title, the Source Frame Rate field shows the DX-700’s currently

selected sync source frame rate. This value changes dynamically when you

select different sources and/or frame rates.

3. In the Sync Source section, select the radio button for the desired genlock

source. Three options are available:

~ If Freerun is selected, the system immediately locks to the DX-700’s

internal timing generator, and the

Freerun Rate section is activated.

• Select a freerun frame rate using the radio buttons in the

Freerun Rate section (50, 59.94, or 60), or set a custom rate.

• Please continue with step

~ If Input is selected, focus jumps to one of your input modules.

• Select an input module and an associated input connector.

• Please continue with step

~ If Master Sync is selected, the bank locks to the master sync source.

You set this source by pressing

{Master} and using the Master Sync

. Refer to the “Setting the Master Sync Source” section on

page 156 for instructions.