user manual

44 DX-700 • User’s Guide • Rev 02
2. Hardware Orientation
DX-700 Rear Panel
4) RGBHV Input
One 15-pin D connector is provided for the RGBHV input. This port accepts
RGBHV inputs up to QXGA, with a maximum 240 MHz pixel clock. The pixel
clock is the speed at which pixels are drawn or refreshed. In Appendix A, refer to
the “
Analog 15-pin D Connector” section on page 179 for pinout information.
5) HD / SDI Input
Two BNC connectors (labelled 1 and 2) are provided for the HD / SDI input. A
variety of input combinations are possible:
~ 2 x SD-SDI — Connect one SD-SDI source to connector 1, and a second
SD-SDI source to the connector
2.
~ 2 x HD-SDI — Connect one HD-SDI source to connector 1, and a
second HD-SDI source to connector
2.
~ 1 x SD-SDI, 1 x HD-SDI — Connect one SD-SDI source to either
connector
1 or 2, and one HD-SDI source to the other connector.
~ 1 x Dual HD-SDI — Connect the (two-wire) Dual HD-SDI source to
connectors
1 and 2.
In all cases, the DX-700 auto-detects which inputs have video present.
6) Component Input
Three BNC connectors (Y / Comp, C / Pb and Pr) are provided for either a
composite, S-Video or Component input. In Chapter 3, refer to the “
Format
Connection Table” section on page 68 for a table of format combinations.
7) DVI / Expansion Input
One DVI-I connector is provided for the DVI / EXP IN port. This port accepts
single or dual DVI inputs, with resolutions up to QXGA (2048 x 1536) with a
maximum 240 MHz pixel clock. In Appendix A, refer to the “
DVI-I Connector
Pinouts” section on page 180 for pinout information.