user manual

DX-700 • User’s Guide • Rev 02 53
2. Hardware Orientation
DX-700 Rear Panel
6) DVI Monitor Out
One DVI-I connector is provided for the DVI Monitor Output. In Appendix A,
refer to the “
DVI-I Connector Pinouts” section on page 180 for DVI-I connector
pinouts. Refer to the “
DX-700 Monitor Outputs” section on page 54 for additional
information on both monitor output ports.
7) DMX In
One XLR5 connector is provided for DMX Input. This port enables you to control
the DX-700 from a lighting console or other DMX-capable device. In Appendix A,
refer to the “
DMX Connector” section on page 184 for pinouts.
8) DMX Thru
One XLR5 connector is provided for DMX Thru. This port enables you to loop
control from the “master” DX-700 to additional slave units. In Appendix A, refer to
the “
DMX Connector” section on page 184 for pinouts.
9) Ethernet
One RJ-45 connector is provided for 100BaseT Ethernet communications with
DX-700, using a socket connection over TCP/IP. The port is typically used for
communications with Barco’s
Director Toolset Graphical User Interface (GUI).
The DX-700 defaults to DHCP operation. The default static IP address is
192.168.000.200. Please note:
~ The DX-700 returns to the DHCP mode after a factory reset.
~ This address can be changed using the Ethernet Menu. In Chapter 4,
refer to the “
Using the Ethernet Menu” section on page 142 for details.
In Appendix A, refer to the “
Ethernet Connector” section on page 183 for
pinouts.
10) Diagnostic Port
One 9-pin D connector (Diagnostic) is provided for RS-232 serial
communications with the DX-700. The port is reserved for factory and technical
support use only.
In Appendix A, refer to the “
Diagnostic Connector” section on page 183 for a
connector illustration.
Note
DMX control is currently not implemented.
Note
DMX control is currently not implemented.