user manual

ManualsBrandsBarco ManualsGraphics TabletRACKMOUNT DX-700

DX-700 • User’s Guide • Rev 02 81

4. Operation

Using the Setup Wizard

pÉíìé=táò~êÇ=jÉåì=qêÉÉë

The Setup Wizard menu tree varies slightly, depending on the type of output module that

you are setting up. The figure below illustrates the Setup Wizard menu tree for

DVI

Output Modules:

Figure 4-5. Setup Wizard Menu Tree for DVI Output Modules

Home Menu

Setup Wizard

Setup Wizard Initial Menu

Bank Selection Menu

Select Output

Display Layout Menu

Display #

Display Reset

H Output Position

V Output Position

Accept Position

Test Pattern Check Menu

Grid SizeNo

Yes

Output Setup Complete

Yes No

Return?

Note: DVI output module selected

Click physical

button in Output

Selection Pane

Panel

Display Output Selection Menu

Click physical

output connector in

rear panel view

Input Wizard

Output Frame Rate Menu

Next PAL

NTSC

Computer

Output Selection Menu

Select Bank

Yes No

Not all outputs set

up. Continue?

Test Pattern Check Menu

Grid Size

Yes No

Moving Smoothly?

Yes No

Select this output as

the reduced/minimum

delay output?

Delay mode

disabled

Standard mode

pre-selected

Reduced or Minimum

mode pre-selected

Set up additional displays

Dis-similar Tiles Similar Tiles

If two or three

outputs are set up

Select one of the outputs

as the reduced/minimum

delay output?

Yes No

Delay Output Selection Menu

DisplayNext

If one output

is set up

If two outputs

are set up

Wall Positioning Menu

Apply Set Columns

Set RowsNext

Yes No

Rolling Smoothly?

Output Position Menu

H Position

V Position

H Size

V Size

Set Direction

Set Start

Display

If all outputs

are set up

Delay Mode Dependency

If one output

is set up

If one output

is set up

If two or three

outputs are set up

Select Output

Setup Dependency