user manual

90 DX-700 • User’s Guide • Rev 02
4. Operation
Using the Setup Wizard
The Display Layout Menu is arranged into four sections:
~ The top section shows the current bank, and provides help text.
Figure 4-19. Setup Wizard: Display Layout Menu (sample)
~ The Display Selection Section enables you to choose an arbitrary
display number (from 1 to 6), for the group you wish to create.
~ The Output Position Section indicates the number of remaining
outputs, enables you to set the selected group’s physical dimensions,
and allows you to “accept” the group’s position.
~ Finally, the Output Selection Section enables you to associate each
output position with a physical DX-700 output.
 Use the following steps to configure a group:
a. In the Display Selection Section, select an arbitrary display number
that you wish to configure (from 1 to 6). Display
1 is the default.
b. In the Output Position Section, indicate how the group is arranged —
in terms of your physical walls. For example:
• If you have three walls constructed side by side, each
connected to an output, your output position is
H3 x V1.
• If you have four walls constructed in a square, then your output
position is
H2 x V2.
Note
Each group that you create is assigned a unique color.
These colors are used on various menus and buttons to
denote the groups. Refer to the “
Group Color Scheme”
section on page 92 for details.
Note
You can also use this control to switch between groups that
have already been set up, to view their configurations.