user manual

92 DX-700 • User’s Guide • Rev 02
4. Operation
Using the Setup Wizard
Note that two additional options are available prior to completing the
“group” configuration procedure:
• If you want to review the available physical outputs, press
{Panel} to display the Display Output Selection Menu.
• Press
{Previous} to return to the Output Selection Menu.
g. With all desired groups configured, press {Next}. If you have not set up
all outputs, you will be prompted to continue. When
{Yes} is selected,
the
Test Pattern Check Menu appears.
21. On the Test Pattern Check Menu, verify that the system-generated test pattern is
moving smoothly, and if required, adjust the grid size (in pixels).
~ Press {Yes} if the test pattern is moving smoothly. The Output Frame
Rate Menu
appears. Please continue with step 22.
~ Press {No} if the pattern is not moving smoothly. The system returns to
the
Display Layout Menu, where you must modify the group(s).
22. On the Output Frame Rate Menu, select the desired output frame rate, then
select
{Next} to display the Output Setup Complete Menu. This completes the
output setup wizard.
~ Press {Next} to enter the Input Wizard. You will be prompted to enter the
Input Wizard; press
{OK} at the prompt. Please continue with the
“
Using the Input Wizard” section on page 93.
~ Press {Home} to exit the Setup Wizard completely.
dêçìé=`çäçê=pÅÜÉãÉ
When you create a group on the Display Layout Menu, unique colors are assigned to
each group, to enable you to identify groups easily and quickly. Once a group is created,
from that point forward, these colors appear on buttons in the
Output Selection Menu, the
Status Menu, and the buttons in the Display Layout Menu.
The figure below illustrates the group color scheme:
Figure 4-22. Group colors
Remember that group numbers are arbitrary reference numbers (from 1 to 6), for the
various groups you can create.
Caution
If you return to the Output Selection Menu, all group
information for the bank will be cleared.
Note
If you exit the wizard, it is strongly recommended that you run
the Input Wizard next.
Group: 1 2 3 4 5 6