Instruction manual

170 ScreenPRO-II • User’s Guide

aK==oÉãçíÉ=`çåíêçä

Using Remote Control

bñíÉêå~ä=pÉêá~ä=oçìíÉê=`çåÑáÖìê~íáçå

The figure below illustrates the connections required for the following configuration:

• Two (or more) ScreenPRO-II units are used as unique destinations.

• One external serial controlled router (RS-232) is used for analog source

connections to each ScreenPRO-II.

• One external serial controlled router (RS-232) is used for SDI source connections

to each ScreenPRO-II.

Figure D-2. ScreenPRO-II Units using External Serial Controlled Routers

 Use the following steps to connect ScreenPRO-II units as destinations, using external

serial controlled routers:

1. Using a standard Ethernet cable, connect the Ethernet Port on the rear of the

ScreenPRO-II chassis to your system’s Ethernet

Hub (or Switch). In Chapter 2,

refer to the “

ScreenPRO-II Rear Panel” section on page 12 for the location of the

Ethernet port.

2. Repeat step 1 as required for each ScreenPRO-II chassis that you wish to use as

a destination.

Encore Controller (SC or LC)

Ethernet

ScreenPRO-II

MatrixPRO SDI Router

MatrixPRO Analog Router

RS-232

Lantronix

UDS200

Ethernet

Outputs

Inputs

Hub / Switch

Note

A completely “local” network is strongly recommended,

without IP connections to the outside world.