Instructions / Assembly

APPLICATION GUIDELINES:
1 Shot N Gone Bio-Barrier
products are the ONLY
products guaranteed, with
proper application, to inhibit
the growth of Mold, Mildew,
Fungus and Odors they cause
on surfaces treated with this
product for weeks and even
years in many applications.
For use on virtually any
interior and exterior surface.
Step 1: 1 Shot N Gone
Bio-Barrier Coatings are not
cleaners they are protectants.
You must thoroughly clean
and or disinfect the affected
areas to remove dirt, grease,
mold and its resulting staining
prior to applying protectant.
We recommend the use of
1 Shot N Gone Bio-Barrier
Cleaner/Prep as it is completely
compatible with the
protectant or any quality
cleaner that leaves no bleach
or soap residue. We also
recommend Wex-Cide 128
as the disinfectant.
OEM use on new material:
Spray a light mist directly on
the surfaces where protection
is desired. Crystal clear when
dry. Will not change finish or
color of substrates.
Step 2: General
Application Guidelines
May be used in cool environments
but DO NOT FREEZE
• COVERAGE average is
800 to 1,500 square feet
per gallon depending on
pourosity of substrate.
• May be applied by spray (air,
airless, LPHV, garden sprayer,
brush, roller, dip, poured,
or cloth/sponge wipe.
• No protective clothing
required but a dust mask
and protective glasses are
recommended for whole
room sprayed application.
A pair of Playtex type rubber
gloves are also recommended
in addition to safety
glasses when applying.
• SKIN CONTACT: Soap
and water clean-up if it
comes in contact with skin.
Only people with hypersensitivities
to chemicals
may experience slight
redness or irritation.
• WARNING: IF A SPRAYER IS
USED IN APPLICATION OF
PRODUCT YOU MUST RUN
CLEAN WATER THROUGH
THE NOZZLE AND HOSE.
FAILURE TO DO SO WILL
RESULT IN A CLOGGED