User manual

User Manual “Instreamer“ - V4.03 - 24th October 2013
SENDING MODE
c=84 : Deactivate the sending mode, if not send
always
c=91 : Activate the sending mode
SERIAL
c=89 : Simulate the CTS Signal being activated
c=90 : Simulate the CTS Signal being deactivated
c=60 : Activate the RTS Signal
c=61 : Deactivate the RTS Signal
For further commands refer to the technical
documentation available on www.barix.com.
SERIAL SETTINGS
When the serial port is not being used as a Serial
Gateway it defaults to a command interface.
Baud rate
Select the serial transmission speed ( "300" to
"115200" Baud).
Default: "9600"
Data bits
Select "7" or "8" data bits.
Default: "8"
Parity
Select "no" , "even" or "odd" parity.
Default: "no
Stop bits
Select "1" or "2" stop bits.
Default: "1"
Flow control
Select the type of flow control: "none" , "Software
(XON/XOFF)" or "Hardware (RTS/CTS)" .
Default: "none"
42 /63 BARIX AG | 28. Jan. 2014 | Device Configuration