Getting Started Guide

Regulatory and Legal Information:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation. Changes
or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna
 Increase the separation between the equipment and receiver

Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
 Consult the dealer or an experienced radio/TV technician for help
This device includes a radio transmitter and receiver. It is designed and manufactured not to
exceed the emission limits for exposure to RF energy set by the Federal Communications
Commission of the U.S. Government. These limits are part of comprehensive guidelines and
establish permitted levels of RF energy for standards that were developed by independent
scientific organizations through periodic and thorough evaluation of scientific studies. The
standards include a substantial safety margin designed to assure the safety of all persons,
regardless of age and health. The exposure standard for portable mobile devices employs a
unit of measurement known as the Specific Absorption Rate (SAR). The SAR limit set by the
FCC is 4.0 W/kg. Tests for SAR are conducted using standard operating positions reviewed by
the FCC with the device transmitting at its highest certified power level in all tested frequency
bands. Although the SAR is determined at the highest certified power level, the actual SAR
level of the device while operating can be well below the maximum value. This is because the
device is designed to operate at multiple power levels so as to use only the power required to
reach the network. In general, the closer you are to a wireless base station antenna, the lower
the power output. Before a portable mobile device is available for sale to the public, it must be
tested and certified by the FCC to not exceed the limit established by the government-adopted
requirement for safe exposure. Tests are performed for each device as required by the FCC in
positions and locations such as on the limb. While there may be differences between the SAR
levels of various devices and at various positions, they all meet the government requirement for
safe exposure. Additional information on Specific Absorption Rate (SAR) can be found on the
Cellular Telecommunications Industry Association (CTIA) website at http://www.ctia.org.