User Manual

Motion detection settings

To call up the menu for motion detection, follow the menu structure: Config> Alarm

Settings> Motion Detection.

1. With standard, the entire image content is used for motion detection. If only a part

of the area is to be used, press the “Motion area set” button followed by the “Clear”

button. Now up to four fields can be set for motion detection using the mouse.

2. The detection sensitivity (Sensitivity) can be set in 5 levels (1 = lowest - 5 =

highest).

3. By setting / removing the check mark next to the "Enable" setting, motion

detection is activated / deactivated.

4. By ticking the box next to the Time 1 and Time 2 settings, two operating periods

can be set for motion detection. If no timer is activated, the motion detection works

continuously for 24 hours.

5. By ticking the box next to a setting in the area of the alarm reaction to motion

detection, this is activated.

Please note that the following functions are not supported by the camera: Contact

output I / O output, local recording record, play audio - audio out.

The use of the email and FTP functions requires further settings in the

corresponding configuration menus.

Camera video stream

The settings of the camera video stream determine the displayed image quality. The

camera has a triple streaming function. The main stream (HD) for a high-resolution

image display and a two low-resolution SD video stream.

Menu structure: Config> Video Settings> Video Coding.

With H.264 / H265 compression, only the changes between two images are

transferred. The bandwidth required for the transmission essentially depends on the

size of the changes between the images, the set image resolution, the set frame rate

and the image details. The H.265 compression is approx. 10% more effective than

H.264 and requires a slightly smaller bandwidth. However, it must be ensured that

the receiving side (NVR, mobile app ...) also supports the H.265 standard.

Coding level: When using the H264 image compression, it can be set to three

levels: Baseline, Main Profile and High Profile.

Coding: can be set between H264 / H265 and MJPEG.

Resolution:There are several resolutions available. Make your selection in the drop-

down list.

Connection to the MKvsion