User Guide

Mounting The Front Sight

**Please note: Front sight is not included when a

crossbow package with scope is purchased.

1. Align the holes of the front sight bracket

with the holes on the prod housing and

attach firmly using the screws and washers

given in the hardware kit. See Figure 4

2. Insert the first sight pin through the bracket with the slotted

screw flush inside the bracket and

tighten down the barrel and washer on

the outside of the bracket. Install the

second pin in the same manner facing

first pin. See Figure 5

Mounting the Rear Peep Sight

**Please note: Peep sight is not included when a

crossbow package with scope is purchased.

1. Slide the rear peep sight onto the

attached dovetail with setscrew

facing the front of the bow.

2. Tighten setscrew when the peep is in

the proper eye relief position with

the hex key provided. See Figure 6

Installing an Optional Scope

The recommended crossbow scope is a Barnett 4x32 mm five-

reticle scope, which includes 1” rings to fit a 3/8” dovetail mount.

1.) Remove peep sight from the scope rail.

2.) Position your scope by moving it forward or backward

until the proper eye relief is found. This is typically three

to four inches from your eye to the eyepiece when you

are holding the crossbow in a shooting position.

3.) After the scope is installed you may remove the front

sight bracket and pins.

Important: Be sure to tighten scope mount rings before shooting

crossbow.

Fig. 6

. 5

. 4