Instruction Manual

Page: 1BA-2041-00/01/03/06/07/13/13B
BIG AIR KIT - Yamaha V-Star 1100
CAUTION! We strongly recommend that a qualified technician install this kit
if you do not completely understand the instructions prior to the install.
Revision: 3.6 - 04/02/2010
Install Time: 2 Hours
INCLUDED IN THE KIT:
(1) Jet Kit BA-2440-00
(1) Chrome Billet BAK Cover
(1) Re-usable Performance Air Filter
(1) Mounting Post
(1) M6 Fender Washer
(1) M6x12mm Chrome Cap Screw
(1) M5x10mm Stainless Button Head Screw
(1) 1/4 -20 Nut
(1) Oil Vent Line, Clear Poly
(1) BAK Filter Raincoat
(1) M5 Stainless Steel Washer
(1) M6 Chrome Washer
(2) 1/4-28 x 1 13/16" Zinc Hex Head Bolts
(3) 1/4" Lock Washers
(1) Foam Filter Material, Green, Trapezoidal
(2) Filter Spacer, Aluminum
(1) Zip Tie 14"
(1) Mounting Arm SS
TOOLS REQUIRED:
3, 4 & 5 mm Allen Wrenches
10mm Open-End Wrench
Pliers (Std. & Needle-nose)
10 & 12mm Sockets
Phillips & Flat Screwdrivers
Factory Service Manual
INSTRUCTIONS:
FIRST STEP: See instructions for installation of included with BA-2440VS Needle/Jet Kit and perform the
complete installation.
NOTE: The V-Star 1100 is prone to excessive oil blow-by from the crankcase vent that extends from the front cylinder head
to the black airbox above the carbs. To prevent excess oil deposits from leaking down into the BAK filter assembly and
blowing out the filter, you must install the supplied oil vent tube and foam filter element into the airbox as follows prior to
installing the new BAK filter assembly.
Loosen the (8) screws and (1) frame bolt holding the top of the black plastic airbox and remove the top.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 [phone] - Ph. [phone] - Fax www.baronscustom.com [e-mail]