Quick Start Guide

Power

• Connect the WAN port to a PoE compatible device. The Secure Connector

powers on automatically.

• Verify that power LED on the front of the Secure Connector is on.

A Power via Power over Ethernet

B Power via Power Supply Unit

• Make sure pin connector is installed correctly.

• Plug in pin connector to appliance 12Vdc.

• Plug in power cord of power supply to outlet. The Secure Connector powers

on automatically.

• Verify that the power LED on the front of the Secure Connector is on.

• Connect the USB cable to the Secure Connector OTG port.

• Connect the other end of the USB cable to your PC.

• The Secure Connector is mounted as mass storage device on your PC. This can

take up to two minutes.

Management PC

Secure Connector’s OTG port

Connect

Setup