Installation Guide

The Barracuda Intruder Defense System consists of three very easy-to-use devices: Model DSI for inward swinging

doors; Model DSO for outward swinging doors; and Model DCS for door closers. The DCS is designed to be used

in conjunction with the DSI or DSO to provide an additional level of security. Due to the wide variety and inconsistency

of door closers and their fasteners, it is not recommended to use the DCS as a standalone solution.

Printed in U.S.A. ©

BILCO Customer Service (800) 854-9724

www.BILCO-barracuda.com

BARRACUDA

™

INTRUDER DEFENSE SYSTEM

Deployment Instructions

PAGE 1
Deployment Instructions BARRACUDA™ INTRUDER DEFENSE SYSTEM The Barracuda Intruder Defense System consists of three very easy-to-use devices: Model DSI for inward swinging doors; Model DSO for outward swinging doors; and Model DCS for door closers. The DCS is designed to be used in conjunction with the DSI or DSO to provide an additional level of security. Due to the wide variety and inconsistency of door closers and their fasteners, it is not recommended to use the DCS as a standalone solution.
PAGE 2
Model DSI For Inward Swinging Doors STEP 1: Lay the device on the floor behind the closed door. STEP 2: Slide the plates under the door. STEP 4: Locate the hole in the bar by sliding the bar as required. STEP 5: Insert the pin to secure the device. Model DSO STEP 3: Push the handles outward to engage the plates on the exterior door jambs. FULLY DEPLOYED For Outward Swinging Doors STEP 1: Position the hook over the door handle so it is facing downwards and the threaded rod is above the cross bar.