Installation Guide

Watch the Barracuda deployment instruction video at www.BILCO-barracuda.com.
STEP 1: Door closers are adjustable for different
size closers. Adjust the bolt to one of the three
holes to ensure a snug fit on the door closer.
FULLY DEPLOYED
*Must be used with DSI or DSO device
Model DSI For Inward Swinging Doors
Model DSO For Outward Swinging Doors
STEP 1: Lay the device on the floor behind
the closed door.
STEP 1: Position the hook over the door
handle so it is facing downwards and the
threaded rod is above the cross bar.
STEP 3: Push the handles outward to engage
the plates on the exterior door jambs.
STEP 3: Push the handles outward to engage
the plates on the exterior door jambs.
STEP 2: Slide the device over the door
closer to secure the door.
STEP 2: Slide the plates under the door.
STEP 2: Position the bar so that the foot
pad rests against the face of the door jamb.
STEP 5: Insert the pin to secure the device.
STEP 4: Locate the hole in the bar by sliding
the bar as required.
FULLY DEPLOYED
FULLY DEPLOYED
The Model DGA mounting cleat should be
used on doors with windows or side lights.
See installation instructions supplied with
the DGA model.
Important: Models DS-LGCLW1 and
DSO-PB-3 for wide door jambs should
only be used with the DGA mounting
cleat. DO NOT deploy these models
directly to a door knob or handle.
Model DCS For Scissor Action Door Closing Devices*