Manual

19
1. Ensure the ON/OFF switch is in the OFF position.
2. Verify the Movable Cutting Table moves freely along the Guide Rails.
3. Inspect the Diamond Blade for damage, cracks and debonding; verify the blade is
correct for the material being cut.
4. Inspect the Pump Assembly for damage - ensure the cord is free of cracks or cuts.
5. Inspect the BD-2003E for damage - ensure all cords are free of cracks or cuts.
BD-2003 CORE SAW INSPECTION & SETUP
Inspect Blade for damage Inspect Pump for damage
PRE-START INSPECTION
Prior to beginning work, a pre-start inspection of the saw should be performed.
ASSEMBLY
(A )
Open the stand and place
it on at surface.
If using the MK Diamond Stand, follow the following steps.
(B)
Set saw on stand as
shown.
(C)
Ensure pins are placed
through holes on frame.
NOTE: