Manual

7
BD-2003 CORE SAW SAFETY
ON / OFF
• ALWAYS wear proper respiratory, head, ear and eye protection
equipment when operating this machine.
• Turn the “ON/OFF” switch to the “OFF” position prior to connecting the machine to
the power source. NEVER leave the machine unattended. Turn off electric motor
when unattended. Know how to stop the machine quickly in case of emergency.
NEVER try to stop a moving blade with you hand.
• CAUTION must be observed while servicing the machine. Rotating parts can cause injury if
contacted. Have all service performed by competent service personnel.
• ALWAYS ensure that the machine is on level ground before using. Keep proper footing and
balance at all times by not overreaching. Keep hands, feet, hair and clothing away from moving
parts to prevent injury.
Establish a training program and give a copy of this manual to operators of this equipment. If you
need extra copies, call TOLL-FREE [phone].
• Operate this machine only in well ventilated areas. NEVER operate this machine in an
explosive atmosphere.
SAW BLADE SAFETY
ALWAYS keep area around the machine clear of obstructions and clear the work area of
unnecessary people. Keep all body parts away from the blade and all other moving parts.
Before starting the machine, check that all guards are in position and correctly tted. NEVER
allow blade exposure from the guard to be more than 180 degrees. DO NOT operate this
machine with the transmission guard removed.
• Inspect the blade, anges and shafts for damage before installing the blade. NEVER use damaged
or worn blade anges.
• Inspect the blade, anges and size shown for each blade size. DO NOT exceed maximum blade
speed shown, as excessive speed could result in blade breakage. Use ONLY blades marked with a
maximum operating speed greater than the blade shaft speed. Verify speed and saw drive
conguration by checking blade shaft RPM and pulley diameters and blade ange diameters.
• Use the correct blade for the type of work being done. Use only reinforced abrasive blades or steel
center diamond blades and anges supplied with the saw or manufactured for use on concrete
saws. DO NOT use carbide-tipped blades. Check with the blade manufacturer if you do not know if
blade is correct.
• Make sure the blade and anges are clean and free of dirt and debris before mounting the blade on
the saw. Verify the blade arbor hole matches the machine spindle before mounting the blade.
ALWAYS mount the blade solidly and rmly. Wrench tighten the arbor nut.
• ALWAYS feed work into a blade or cutter against the direction of rotation. A blade or cutter should
always be installed such that rotation is in the direction of the arrow imprinted on the side of the
blade or cutter.