User Manual

9
Main Motor Leeson A4SI7DR56
Horsepower 1/3 HP
Motor Voltage 115 volt/60Hz / 220 volt/50Hz
Amperage 5.8 Amps / 3.5 Amps
Motor RPM 1725 RPM Fixed / 1425 RPM
Blade Shaft 5/8"
Duty Continuous
Motor Arbor Bearings Ball Bearings, permanently sealed
Arbor Diameter 5/8"
Blade Capacity 8", 9" or 10" diameter
Dimensions L x W x H 27" x 17" x 19"
Power Feed Motor REX
Horsepower 1/15 HP
Motor Voltage 110 volt/60Hz / 230 volt / 50/60Hz
Motor RPM 5 RPM (full load) Fixed
Torque 50 inch-lbs.
Rotation Clockwise facing the shaft
Motor Arbor Diameter 5/16"
Motor Arbor Bearings Sleeve-bushing type, permanently sealed
POWER FEED TOGGLE SWITCH CONTROL POSITIONS
1. ON/POWER FEED Position – Provides power from the main motor to the blade arbor and power feed motor.
2. OFF Position – Both power feed and main motors off.
3. MANUAL FEED position - Provides power from the main motor to the blade arbor.
Blade Arbor Bearings: Permanently sealed 5/8" OD shaft ball bearings press fit into aluminum housing (must be
ordered with aluminum housing as an arbor assembly when bearings are worn out.)
Blade Arbor Flanges: Aluminum, 2" OD x 5/8" bore.
Power Feed Threaded Rod: 18" long x 3/8"-24 left hand thread stainless steel rod.
Power Feed Clutch Block: Two piece: silicon bronze half-threaded 3/8"-24 thread friction block.
Rock Vise Capacity: 3-1/4". (Maximum opening between clamping studs)
Cross Feed Index Movement per Revolution of Handle: 1/16".
Power Feed In-Feed Vice Advancement Rate: approximately 3/16 of an inch per minute.
Blade Lubricant Requirements: 0.31 gallon of oil to adequately cover the bottom of a 10” blade and 0.62 gallon
for an 8” blade (Fig. 2).
Shipping Weight 80 lbs. crated (70lbs. uncrated)
Depth of Cut 3" manual feed, 2-5/8" with vise
Oil Capacity 10" Blade, 0.31 gallon; 8" blade 0.62 gallon
BD-10 SPECIFICATION