Instruction Manual

RE-CIRCULATION

When using the re-circulation method, the water should be changed often for longer pump life.

(A)

Ensure the Drain Plug is in-

stalled in the Water Basin.

MK-100 SETUP

NOTE:

(B)

Place the Water Pump in the

back of the Water Basin.

MK-100 SETUP FOR OPERATION

Before powering or starting, check for damage that could prevent this equipment

from proper operation or performing it's intended function. Check for binding and

alignment of moving parts. Check for damaged, broken, or missing parts.

CAUTION

In order to avoid breaker tripping, a 20 amp circuit breaker should be used.

Voltage 120v

Cycle 60Hz

Phase 1-phase

If using an extension power cord, make sure the length and wire gauge correspond to he

requirements listed in the Table on Page 10. An extension power cord that is too small in wire gauge

(diameter), or too long in length, will cause the motor to overheat and could cause premature failure.

Use an approved Ground Fault Circuit Interrupter (GFCI).

Do not cover the motor vents as this could lead to motor overheating.

NOTE:

Ensure the power cord and cooling tube exit the water basin under the top rail of the frame.

NOTE:

Verify the ON/OFF switch is in the OFF position.

Before connecting the MK-100 to a power supply, be sure the voltage, cycle and phase of the job

site power source meet the requirements in the table below.