Instruction Manual

MK-100 OPERATION

PORTABLE GENERATOR

GROUND FAULT INTERRUPTER

If using a portable generator to provide power, ensure the generator meets the following minimum

requirements: 8Kw 120 Volts 20 Amps Single Phase

Ground Fault Interrupters (GFCI) provide protection from the dangers of electrical hazards.

Receptacles are available having built-in GFCI protection and may be used for this measure of safety.

Otherwise a GFCI should be used.

(A)

Ensure the ON/OFF Switch is

in the OFF position.

(B)

Plug MK-100 into GFCI.

(C)

Plug the GFCI into

the power source.

SET CUTTING DEPTH

When loosening the Cutting Head Adjusting Knob, the Cutting Head will pivot

down unless held.

If the plug or receptacle does get wet DO NOT plug/unplug the cord.

Disconnect the fuse or circuit breaker that supplies power to the tool.

Then unplug and examine for presence of water in the receptacle.

(A)

Loosen Cutting Head

Knob and move Cutting

Head down.

(B)

Set cutting depth approxi-

mately 1/4 to 1/2 inch below

the surface of the Movable

Cutting Table.

(C)

Ensure the Adjusting

Knob is tight.

CAUTION

WARNING