Instruction Manual

MK-100 OPERATION

(D)

Perform the cut. Turn the motor

OFF when work is complete.

45° Miter Cutting

DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for

which it was designed.

To cut 45° Miters, the 45° Bullnose Miter Guide should be used (MK Diamond

Part # 134585-MK).

CAUTION

NOTE:

(A)

Position the 45° Bullnose

Miter Guide and tighten the

retaining thumbscrews.

(B)

Position the tile on the 45°

Bullnose Miter Guide and the

Ruler/Stop. Turn ON the motor.

(C)

Verify proper cooling ow on

both sides of the blade (See

Maintenance Section to

increase/decrease ow).

(D)

Perform the cut. Turn the motor

OFF when work is complete.