Instruction Manual

Off-angle Cutting

DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for

which it was designed.

CAUTION

(A)

Place the 90° Protractor on

the Ruler/Stop and tighten the

retaining thumbscrew.

(B)

Set the desired angle and

tighten the thumbscrew.

(C)

Position the tile against the 90°

Protractor and the Ruler/Stop.

Turn the motor ON.

(D)

Verify proper cooling ow on both

sides of the blade (See Mainte-

nance Section to increase/de-

crease ow).

(E)

Perform the cut. Turn the motor

OFF when work is complete.

MK-100 OPERATION

To cut angles other than 45° angles or Miter, a 90° Protractor (MK Diamond Part

No. 134569-MK) should be used.

NOTE: