Instructions / Assembly
4
Gate Installation:
The opening between the posts should be 1
1
⁄2"
wider than the gate width to allow for hinges.
(Example: Use a 48" opening for a 46
1
⁄2" wide
gate.) Be sure posts are level and plumb.
Fig. 4
Example:Example:
Frost Line
Gravel/
Filler
6"
X+Y
Y
X
Fig. 5
4.
3.
Post Location:
Measure the width of the fence panel (X) plus the
width of the post (Y). This is the common center-
to-center measurement (unless there is a cut-down
panel) for post hole location (Fig. 4).
Post Installation:
Dig rst two post holes 6" in diameter and down to
your specied frost line. Insert ller/gravel into the
bottom of both holes and then set rst post in post
hole.
Add wet or dry concrete mix according to the
manufacturer’s instruction to the top of the hole for
rst post only and level it.
Example: When your frost line is 36" insert 12"
of gravel/ ller and 24" of post withconcrete
surrounding (Fig. 5).