Instructions / Assembly

5
Fig. 13
ReleaseRelease
Fig. 12
Once gate is aligned and adjusted correctly, snap
on decorative hinge covers (Fig. 13).
NOTE:
HINGE TENSION IS PRE-SET AT THE
FACTORY AND USUALLY DOES NOT REQUIRE
ADJUSTMENT. If you wish to change tension
setting/gate swing speed, or completely
disable the self-closing feature, please see the
following:
Hinge Tension Adjustment:
a. Remove cover from hinge. Place included Allen
wrench into head of tension adjustment pin in
hinge. The head is at the end closest to the "+"
or "–" symbol on the hinge barrel (Fig. 11).
NOTE:
DO NOT remove the Allen wrench or release the
tension on the tension adjustment pin at any
time during the adjustment.
b. Following the indicators on the "+" or "–"
symbol on the hinge barrel, press down on the
tension adjustment pin and turn a quarter turn
toward the "+" to tighten, or toward the "–" to
loosen until satised (Fig. 11).
c. Self-closing feature can be disabled by using
the Allen wrench to push down and turn
towards the "–" symbol until the gate no longer
shuts on its own.
d. Do not over-loosen the tension adjustment pin,
as this may damage the tension spring.
e. When you have set the desired tension, simply
release the downward pressure on the tension
adjustment pin to lock it back into the hinge
barrel. Tabs on pin head will t into notches in
hinge barrel when pin is in fully locked position
(Fig. 12).
Press DownPress Down
Fig. 11
Allen WrenchAllen Wrench
4.
5.