Programming Manual

i480e&i480e-MD2 Programming Manual
102 / 139
Parameters
callheld
0:No calls held;
1: Call is placed on hold or active/held calls swapped
(The AG has both an active AND a held call);
2: Call on hold, no active call.
status
Values in the chapter 20.1.1.
Note
N/A
20.14 AGCOPS
The AGCOPS command is used to send network operator to HF, only for HFP.
Command
AT+B AGCOPS [mode],[operator]
Response
AT-B AGCOPS [status]
Parameters
mode
The current mode and provides no information with
regard to the name of the operator.
operator
Specifies a quoted string in alphanumeric format
representing the name of the network operator and
this string shall not exceed 16 characters.
status
Values in the chapter 20.1.1.
Note
N/A
20.15 AGCMEERR
The AGCMEERR command is used to send extended error result code to HF,
only for HFP.
Command
AT+B AGCMEERR [errorcode]
Response
AT-B AGCMEERR [status]
Parameters
errorcode
0: AG failure;
1: no connection to phone;
3: operation not allowed; 4:
operation not supported; 5:
PH-SIM pin required;
Barrot Confidential