Programming Manual

i480e&i480e-MD2 Programming Manual
108 / 139
20.23 AGMUTE
The AGMUTE command is used to mute on/off microphone or speaker when a
call is ongoing.
Command
AT+B AGMUTE [op]
Response
AT-B AGMUTE [status]
Parameters
op
0: mute off;
1: mute microphone on, mute speaker off;
2: mute speaker on, mute microphone off;
3: mute both speaker and microphone on.
status
Values in the chapter 20.1.1.
Note
N/A
20.24 AGCIND
The AGCIND command is used to send the current status of the AG indicators.
Command
AT+B AGCIND [service],
[call],[callsetup],[callheld],[signal],[roam],[battery]
Response
AT-B AGCIND [status]
Parameters
service
Whether or not a service is present.
0: no service;
1: presence of service.
call
0: means there are no calls in progress;
1: means at least one call is in progress.
callsetup
0: means not currently in call set up;
1: means an incoming call process ongoing;
2: means an outgoing call set up is ongoing;
3: means remote party being alerted in an outgoing
call.
callheld
0: No calls held;
1: Call is placed on hold or active/held calls swapped
Barrot Confidential