Programming Manual

i480e&i480e-MD2 Programming Manual
41 / 139
6.9HFMCAL
The HFMCAL command is used to change three-way calling status (active or held).
This command will be successfully executed when the HFP instance is in either
hsActiveCall or hsTWCallWaiting status.
Command
AT+B HFMCAL [op]
Response
AT-B HFMCAL [status],[op]
Parameters
op
Operation code, where
0: MultipleCallsReleaseHeldOrRejectWaiting;
1: MultipleCallsReleaseActiveAcceptOther;
2: MultipleCallsHoldActiveAcceptOther.
status
Values in the chapter 6.1.1
Note
N/A
6.10 HFCLCC
The HFCLCC command is used to get current calls list of AG side, for Hands-free
profile only.
Command
AT+B HFCLCC
Response
If one or more current calls found:
AT-B HFCCIN [status],[call_idx],[direction],
[mode],[multiparty],[number_type],[number]
When the command finished:
AT-B HFCLCC [status]
Parameters
call_idx
Call index, defined by AG.
direction
AG originated call indicator, where
0: Call from AG to network;
1: Call from network to AG.
status
Call status, where
Barrot Confidential