Programming Manual

i480e&i480e-MD2 Programming Manual
46 / 139
Command
AT+B HFBVRA [enable]
Response
AT-B HFBVRA [hfp_lib_status]
Parameters
enable
1: enable voice recognition;
0: disable voice recognition;
hfp_lib_status
Refer to chapter 6.1.1
Note
N/A
6.19 HFCOPS
The HFCOPS command is used to Get the network operator for the AG.
Command
AT+B HFCOPS
Response
Succeeded: AT-B HFCOPS [mode],[operator]
Failed: AT-B HFCOPS 1
Parameters
mode
Network operator selection mode, currently not used,
so ignore it.
operator
Operator name string, shall not exceed 16 character.
Note
N/A
6.20 HFMCAL
The HFMCAL command is used to operate three-way calling.
Command
AT+B HFMCAL [op],[index]
Response
AT-B HFMCAL 0
Parameters
op
Operation code, in where:
0 : Releases all held calls or sets User Determined User
Busy (UDUB) for a waiting call.
1: Releases all active calls (if any exist) and accepts the
other (held or waiting) call.
2 : Places all active calls (if any exist) on hold and
Barrot Confidential