User's Manual

10.1" Tablet PC - Agile X IS
Type 17-A1B*-****/********
Operation
Subject to technical changes.
12/2016
49/50
7.4 Operating frequency - FCC and IC
5 GHz Only
The use in the UNII (Unlicensed National Information Infrastructure) band 1 5150 -5250
MHz band is restricted to Indoor Use Only; any other use will make the operation of this
device illegal.
Industry Canada Statement
CAUTION - AVERTISSEMENT
Devices can be damaged by inappropriate handling!
 The device for operation in the band 5150-5250 MHz is only for indoor use to
reduce the potential for harmful interference to co-channel mobile satellite
systems;
 High-power radars are allocated as primary users (i.e. priority users) of the bands
5250-5350 MHz and 5650-5850 MHz and that these radars could cause
interference and/or damage to LE-LAN devices.
Devices can be damaged by inappropriate handling!
 Les dispositifs fonctionnant dans la bande 5 150-5 250 MHz sont réservés
uniquement pour une utilisation à l’intérieur afin de réduire les risques de
brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes
canaux;
 De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de radars
de haute puissance sont désignés utilisateurs principaux (c.-à-d., qu’ils ont la
priorité) pour les bandes 5 250-5 350 MHz et 5 650-5 850 MHz et que ces radars
pourraient causer du brouillage et/ou des dommages aux dispositifs LAN-EL.
2.4 GHz only
In the USA the channels 1 to 11 are available for the 802.11 b/g operation. The range of
channels is restricted by the firmware.
FCC requirements to protect against high-frequency interference
This device has been tested and satisfies the limit
values for a digital device of Class B according to Part
15 of the FCC Guideline. These limit values were
stipulated to guarantee appropriate protection against
disturbances if the device is used in residential areas.
The device generates and uses radio frequency energy and may emit this energy. This
can have a disturbing effect on other radio frequencies if the device is not connected and
used in accordance with the operating instructions. A guarantee that no interference will
arise for a certain installation cannot be given.
If the device causes interference to the radio or TV reception which can be recognised by
switching the device on and off, the interference should be eliminated by one or several of
the following measures:
 Re-alignment or moving of the receiving aerial.
 Enlarging the distance between device and receiver.
 Connecting the device to a different socket than the one to which the receiver is
connected.
 Advice from the dealer or a radio/television technician.