User's Manual

10.1" Tablet PC - Agile X IS
Type 17-A1B*-1***/********
Service, Inspection and
Repair
Subject to technical changes.
12/2016
53/50
Problem Solution
The GPS is very inaccurate.
 When using the GPS we recommend that the 1D/2D imager be
deactivated to avoid faults.
There is no sound from the
loudspeaker.
 Check the volume setting with the buttons for high and low.
 When using external audio devices check whether the cable has
been connected correctly.
The display of the Tablet PC cannot
be displayed on an external monitor.
 Check whether the VGA driver is installed.
 Check that the output settings are correct.
No laser appears with the 1D/2D
imager and it does not appear to
work.
 With the hot tab tool, check that the 1D/2D imager is active.
 In the system settings, check that the 1D/2D imager is set to
COM15 so that the hot tab tool has access.
The laser appears with the 1D/2D
imager but no data are shown.
 Reduce the distances between the 1D/2D imager.
 In the 1D/2D imager configuration, check whether the barcode
type use is active.
The RFID reader does not work.

In the system settings, check whether the RFID reader is set to
COM3 so that the hot tab tool has access.
8.2 Resetting the Tablet PC using the recovery function
ATTENTION
Recovery can cause data loss!!
 Data which are stored on the Tablet PC and are not subject to data backup will be
deleted and loss irretrievably.
 You should therefore first conduct a data backup in order to prevent data loss.
Every Tablet PC is supplied with a recovery partition and permits a 1-key recovery
procedure.
Work steps:
Conduct the recovery function only outside of potentially explosive atmospheres. Only
start and conduct the recovery function if the Tablet PC is connected to an external power
supply.
1. Switch on the Tablet PC using the Power button.
2. When the boot screen appears, there are two ways of reaching the recovery menu.
 Press Fn1 button on the front side of the Tablet PC.
 When using an external USB keyboard, press the F6 button
3. The following screen of the recovery function appears.