User manual
Safety Instructions 
3 
2  Safety Instructions 
  Take the device out of the hazardous areas before wiping it with a dry cloth or cleaning it! 
  Do not exchange batteries of the type B7-A2Z0-0001 and B7-A2Z0-0003 in the hazardous area! 
  Do not open or charge the device and do not exchange any data through the "cradle contacts" 
on the battery in the hazardous area! Operating the 17-pin data interface (see chapter 3.5 
"Technical Data Battery, Article "External Battery Contacts") is only permissible outside the 
hazardous area and only with devices specified by the manufacturer! 
  The device may not be opened by the user outside the hazardous area either! The user may not 
make any alterations to the device. Do not exchange or replace components and do not retrofit 
any components on internal plug connectors or slots. If components other than those specified 
are used, the protection against explosions can no longer be assured. 
Exception:  Keypad and SD card
(see chapter 6.1 "Keypad and SD Card")
  Protect the device from impact effects! Do not expose the operating equipment to any 
caustic/aggressive liquids, vapours or mist! In the event of malfunctioning or damage to the 
enclosure, take the equipment out of the potentially explosive atmosphere immediately, bring it 
into a safe area and decommission it by removing the battery! 
  If on account of adverse effects or conditions (e.g. penetration of water, fluids, exposure to 
temperatures outside the specified range etc.) there is a danger of not being able to operate the 
equipment safely, switch off the equipment instandly and remove it out of the hazardous area. 
  General statutory regulations or directives on safety at work, accident prevention regulations 
and environmental protection legislation must be complied with, e.g. Ordinance on industrial 
health and safety (BetrSichV) or the national ordinances. 
  Ensure safe handling of the equipment during operation by making sure the device in a steady 
position and the user has sufficient space to move! 
  After use, the equipment must be placed where it will be sheltered from falling objects and out 
of danger of falling itself. This must also be ensured even if only putting it down for a short time 
when taking a break from work. 
2.1  Warnings about the Mobile Computers










