Datasheet

Josef Barthelme GmbH & Co. KG
Oedenberger Straße 149
D-90491 Nürnberg
www.barthelme.de
[e-mail]
Technische Änderungen und Irrtümer vorbehalten. / Subject to technical changes and errors.
Datum / Date: 07.2016 AST Revision: 1.5 Seite 3 von 3
− Bei Einsatzbereichen mit Einfluss von Staub oder Feuchtigkeit ist das LEDlight flex mittels einer Leuchte mit einer geeigneten
Schutzart zu schützen. Das Modul kann durch eine Nachträgliche Lackierung gegen Kondenswasser und Feuchtigkeit geschützt
werden. Der zu verwendende Lack muss folgende Eigenschaften erfüllen:
⇒ Transmissionsfähigkeit
⇒ UV-Stabilität
⇒ Temperaturzyklenbeständigkeit im zugelassenen Temperaturbereich
⇒ niedrige Wasserdampfpermeation bei allen Klimaten
⇒ Beständigkeit gegen korrosive Atmosphären
Verwenden Sie ausschließlich von uns freigegebene Lacke und Silikone!
Security advice
− Mechanical stresses of the devices on the LED modules are to be avoided!
− During the mounting process the PCB may not be damaged or interrupted.
− Only an electronically skilled person is allowed to do the installation of LED modules (with power supply) in consideration of all
valid instructions and norms.
− Please pay attention to polarity and correct side of feeding-in (left-sided with correct reading direction on the LED stripe)! With an
incorrect polarity, there will be no light emission or the LED module can be damaged!
− Only a secure operating state submits a parallel connection. Please avoid a series connection of the LED module. Unsymmetrical
voltage drop may cause a strong overloading and destruction of single modules.
− Please pay attention to the dimensioning of your available power supply; dimming is only possible with PWM, or similar
− To avoid any short circuits at the solder patches by mounting on metallic surfaces, there should be an insulator between module
and mounting surface.
− The maximum length of an associated LED module is approximately 8.4m. Longer LED modules can be obtained by intermediate
feeding or feeding at the beginning and end of the LED module.
− A sufficient cooling has to be respected, e.g. by sticking to metallic surfaces.
− Please be aware of ESD while mounting.
− LEDlight flex will be delivered unvarnished, i.e. without corrosion prevention.
− Corrosion defects caused by the contact with condensation or humidity cannot be granted.
− The maximum current per reel (max. length) is 2.5 ampere for a short time. When using a power supply with an output current of
greater than 2.5 ampere, the modules must accordingly be fused with a super quick protection.
− By using LEDlight flex in a field of application with the influence of dust or humidity, it has to be protected properly. It can
be protected against condensation or humidity by lacquering afterwards. The lacquer must have the following features:
⇒ Ability to transmit
⇒ UV ray resistance
⇒ resistance temperature cycles in the approved temperature range
⇒ low water damp permeation by all climates
⇒ resistance to corrosive atmospheres
− Only use lacquers and silicones approved by us!