Specifications

BARTINGTON INSTRUMENTS
Page 17 of 18 OM2443/2
11.1. Fuses
As a safety feature the PSU1 is fitted with a thermal fuse. If the PSU1 overheats, which could
occur as a result of the fitment of incorrect battery cells, the charging circuit will be permanently
isolated. The PSU1 must be returned to Bartington Instruments for checks and repair.
11.2. Calibration
No calibration is required.
11.3. Cleaning
Caution: Disconnect the electrical supply before performing any cleaning operation.
Periodic cleaning is not normally required.
If the system becomes soiled and cleaning is necessary:
1. Use a damp cloth to clean the outer surfaces.
2. Use an air duster to blow debris from the connectors.
Caution: Ensure water does not enter the system. The system must be completely dry
before the electrical supply is reconnected.
Caution: Never use chemicals, such as solvents, when cleaning the PSU1.
Caution: Take particular care when cleaning around electrical connections. Bent or
damaged pins may cause the magnetometer to malfunction.
12. End of Life Disposal
This product should not be disposed of in domestic or municipal waste. For information about
disposing of this product safely, check local regulations for disposal of electrical / electronic
products.
12.1. Waste Electrical and Electronic Equipment (WEEE) Regulations
This product complies fully with Restriction of the Use of Certain Hazardous Substances in
Electrical and Electronic Equipment (RoHS) and WEEE Regulations current at the time of
writing.