Owner's Manual

6
CANADIAN COMPLIANCE STATEMENTS FOR WC20
The Industry Canada (IC) label identifies certified equipment. This certification means that
the equipment meets certain telecommunications network protective, operational, and
safety requirements. The department does not guarantee the equipment will operate to the
user’s satisfaction.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of the device.
Before installing this equipment, make sure you are permitted to connect it to the facilities
of the local telecommunications company. You must install the equipment using an
acceptable method of connection. In some cases, you may also extend the company’s
inside wiring for single individual service by means of certified connector assembly
(telephone extension cord). You should be aware, however, that compliance with the
above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance
facility designated by the supplier. Any repairs or alterations made by a user to this
equipment, or equipment malfunctions, may give the telephone communications company
cause to request the user to disconnect the equipment.
For your own protection, make sure that the electrical ground connections of the power
utility, telephone lines, and internal metallic water pipe system, if present, are connected
together. This precaution may be particularly important in rural areas.
(IC) applicable REN number is 0.6B.
CAUTION
Do not attempt to make electrical ground connections yourself, contact the appropriate
electrical inspection authority or an electrician.
NOTICE
The Ringer Equivalent Number (REN) assigned to each terminal device provides an
indication of the maximum number of terminals allowed to be connected to a telephone
interface. The termination on an interface may consist of any combination of devices,
subject only to the requirement that the sum of the REN numbers of all devices does not
exceed 5.
EMISSION REQUIREMENT
This Class B digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulation.
WARRANTY AND REPAIR SERVICE IN CANADA:
Barton Instrument Systems
3840 - 11A Street N.E.
Calgary, Alberta T2E 6M6
[phone]
CE COMPLIANCE STATEMENT FOR WC21
This product has been tested and confirmed to be in compliance with all EU EMC and
LVD Directives (in effect at the time of testing) for light industry use. There may be a
temporary degradation of performance at extreme levels of electro-magnetic interference.
This instrument complies with the Low Voltage Directive 73/23/EEC. For further details,
contact Barton Instrument Systems.
Approvals Pending
Certification No.: CAN 33991032172A