CANF-20 ELECTRIC FIREPLACE Installation Instructions WARNING! IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A FIRE MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
TABLE OF CONTENTS PLEASE READ THE INSTALLATION & OPERATIONS INSTRUCTIONS BEFORE USING THIS APPLIANCE IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty.
INTENDED USE: This product is intended only for indoor household or office use. It is NOT intended for industrial or commercial use. DO NOT USE OUTDOORS IMPORTANT INSTRUCTIONS PLEASE READ AND SAVE THESE IMPORTANT SAFEFTY INSTRUCTIONS When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons, including the following: 1) Read all instructions before using this heater. 2) This heater is hot when in use.
ZONE HEATING SAVES! The concept of Zone Heating is simple. Use High Efficiency heaters to heat the rooms you use most, during the times you use these areas and turn back the thermostat to your central heating system. To achieve the maximum benefit it is important to understand your heater and where best to locate it. Please follow these suggestions: 1. 2. 3. 4. 5. 6. Close doors to areas you do not wish to heat. Locate an outlet along an interior wall if possible.
PRODUCT DIAGRAM ~5~
OPERATING YOUR HEATER 1. First turn on the Power switch on the right side of the heater. You will hear a beep indicating power is supplied to unit. The Power switch supplies power to all the function of the appliance. This switch must be in ā Iā position for any functions including the remote control to work. 1. Setting Temperature Press the Power button, the heat and flame effect will be on. Press the Power button again, heat and flame effect will be off.
5. Setting flame There are 6 brightness levels that can be selected work. Settings 1 -3 increase in brightness with flicker. Settings 4 -6 increase in brightness without flicker. MAINTENANCE 1. Turn off the heater of the power switch. 2. Unplug the unit and let it cool completely. 3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid enter the heater. 4.
ALWAYS OBSERVE THESE SAFETY PRECAUTIONS WHEN OPERATING YOUR ELECTRIC HEATER ALWAYS Read all instructions before operating. ALWAYS Locate your electric heater away from furniture or loose hanging drapes. ALWAYS Keep the rear grill away from walls or drapes so as not to block the air intake. (If applicable) ALWAYS Unplug electric heater when not in use. ALWAYS Use electric heater on a flat dry surface. ALWAYS Use on 120 volt 60Hz AC power supply.
ELECTRIC HEATER WARRANTY LIMITED WARRANTY: A limited warranty is extended to the original p to manufacturing defects for a period of (1) one year from the date of retail purchase. Please read and follow all details noted below. DUTIES OF THE OWNER: This heating appliance must be operated in accordance with the written instructions furnished with this heater. This warranty shall not excuse the owner from properly maintaining this heater in accordance with the written instructions furnished with this heater.