Installation Guide

OPERATING YOUR HEATER
1. First turn on the Power switch on the right side of the heater. You will hear a beep indicating power is
supplied to unit. The Power switch supplies power to all the function of the appliance. This switch must be in
“ I” position for any functions including the remote control to work.
1. Setting Temperature
Press the Power button, the heat and flame effect will be on. Press the Power button again, heat and
flame effect will be off. The fan will continue running for 30 seconds to disperse remaining heat
from inside.
2. Setting timer to power-off
Press the Timer button to set timer-power-off function through control panel. Press the Timer button
to increase duration from 1h-2h-3h-4h-5h…….8h. The display panel will show 01-02-03-04-0508.
3. Setting heat
Press the Heater button on the control panel, the heater will start, it is Low heating model, The
display panel show LL,, press it once again, it is High heating mode, The display panel show HH
press the button the third time, the heater will be off, the fan will continue running for 30 seconds to
disperse remaining heat from inside. When LL or HH is displayed, the heater is normally open and is
not affected by temperature control.
4. Setting Temperature
Control temperature settings to choose temperature as desired . Setting range from 62 F to 82 F. Press
once. Indicator light turn on.Temperature is set to 62 F. Increase 2F per press. 14 Settings display:
62,64,66,68,70,72,74,76,78,80,82,84,86,88
~ 6 ~